P0313 OBD2 Error Code - Misfire Detected with Low Fuel

OBD-II (On-Board Diagnostics II) is the standard system in most cars from 1996 onward that monitors the engine and emissions. When the check engine light comes on, the ECU (engine control unit) stores one or more trouble codes. Codes starting with P relate to the powertrain (engine, transmission); the code discussed on this page falls into that category.

The information here is for education and reference only. For an accurate diagnosis and repair, always consult a qualified technician or service centre.

Misfire Detected with Low Fuel

The P0313 code indicates an issue detected by your vehicle's engine control unit (ECU). This code can affect your car's performance, emissions, or fuel efficiency. The severity depends on the code type and symptoms you're experiencing.

Seeing a code like P0313 doesn't always mean an expensive repair. Understanding what the code and its possible causes mean, then getting a proper diagnosis at a trusted shop, helps you avoid both unnecessary spending and damage from leaving the issue unchecked.

Short trips at low load are acceptable. Long journeys or heavy loads are not recommended; get a diagnosis as soon as possible.

Costs vary by root cause and vehicle model. Simple cleaning procedures may range from $50-150 USD, while sensor replacement can be $100-300 USD, and complex repairs may cost $300-1000+ USD. Diagnostic fees are typically around $50-100 USD.

Getting quotes from more than one shop and seeing the work in writing can help.

You should see a mechanic in the following situations:

• The check engine light is on and you notice performance issues
• The vehicle won't start, stalls, or cannot be driven safely
• The code returns after clearing it
• Electrical issues or complex repairs are needed
• An emissions test is approaching and the code needs to be cleared

Professional diagnosis helps identify the true root cause and avoid unnecessary part replacements.

Many drivers look up the code online when the check engine light comes on; this page is here for that purpose. Sharing what you have read with your technician and asking “This code came up—what do you think could be causing it?” can make the diagnostic process smoother.

The code alone does not identify the faulty part; vehicle and measurement can yield different results. Have OBD-II reading and necessary checks done at a qualified workshop.

Level: Low

Low severity: This code typically indicates a minor issue and short-term driving is usually safe. However, get the issue fixed. There may be a risk of failing emissions tests.

Real-world scenario: The P0313 code typically appears when you start your vehicle and the check engine light comes on. Your car may seem to run normally, but you might notice performance issues or increased fuel consumption. In some cases, the vehicle may idle roughly or experience power loss during acceleration.

In this scenario, the driver should first read the code and check the live data stream. Electrical tests should be performed to identify the root cause, and relevant components should be replaced if necessary.

In short: OBD-II codes are clues your car gives you. When interpreted correctly, they can save you time and money and help you stay safe on the road. The information on this page is a general guide; for diagnosis and repair specific to your vehicle, always consult a qualified technician.